Note: For this configuration, do NOT enable PoE Passthrough as referenced in the section above. If you power the first radio through the "Secondary" port rather than the "Main" port, power is not lost to the next device if the first radio is rebooted. It is a similar configuration to the previous one, but with an added feature. PoE Linking: Two Independently Powered M Devices & One PoE When enabled, the device allows Power over Ethernet (PoE) power to pass from the main port to the secondary port, thereby powering an additional device.įrom within the airOS AC configuration console, navigate to the Settings tab, go to Device and enable PoE Passthrough.įrom within the airOS M configuration console, navigate to the Advanced tab, go to Advanced Ethernet Settings and enable PoE Passthrough. This configuration is only possible when the Ubiquiti device has a secondary Ethernet port which can be activated for PoE Passthrough. PoE Bridge & Passthrough: Three or Four Devices & Two PoE.PoE Linking: Two Independently Powered M Devices & One PoE.Different devices have different power specifications, please remember to always verify powering data in each device's Data Sheet and Quick Start Guides, found in our Downloads page. This article covers different possible combinations using a NanoStation 5AC as an example. This article demonstrates four different scenarios for a PoE Bridge with airMAX devices.
0 kommentar(er)
